3D Camer Photos
In this project, I used a 3D-printed camera; with black and white 35mm film. Photos are from a walk-in downtown Msheireb. Each photo was exposed to 10 to 20 seconds of sunlight. The lens was created from a soda can and punctured by a small needle. the aluminum reflected the sun rays into the film to engrave these beautiful photos.
(created 2020)
2nd Part
Using the photo I took I inverted to negative images on photo shop as seen below
Then I Cyanotype (Cyanotype is a photographic printing process that produces a cyan-blue print. The process uses two chemicals: ferric ammonium citrate and potassium ferricyanide. It looks yellow and when exposed to uv light and rinsed it turns blue and white)
Photos used in the process were not used for final.
Then I used coffee, Black tea , and hibiscus tea. Each one with different concentration can change the color of your cyano print after 24 hours. The final results showed that hibiscus tea only made the print a little vibrant. The coffee made the print grey-ish with brown, and final black tea turned the print into dark brown hues.
Final Outcome
